8/17/2023 0 Comments Signal art reamp boxThis setup leaves you with strong, centered low frequency focus, but adds an interesting distorted ‘width’ component. For maximum sum and difference affect, mic the amp off-axis. Use the return from the amp just as you would use the ‘side’ component of a mid-side mic array.Somewhere in signal flow, HPF this path in the 300 – 500Hz neighborhood. Set up a nicely overdriven bass tone on an amp.Get it sounding great, and set up a re-amp path Use a DI bass right up the middle of your mix.I think it kills for gritty bass, particularly with tight, close drums. On keyboard tracks, for example, I will frequently make significant, crossover-style EQ choices that allow me to more subtly combine the unique elements of each signal type.Īnother technique that can be used with remarkable ease is one I dubiously call “Sum and Amp-ness”. This conflict can often be resolved by creating more contrast between the original and re-amped signals. In these cases there’s usually something unique about each signal, but they may not be working together well. Sometimes it can be difficult to decide whether the original signal should be used in combination with the re-amped signal. Regardless of your choice of tool, remember that relative phase is a subjective tone control in this setting. ![]() This allows the mic to stay in the spot you liked the most. Used as the re-amping adapter or after the mic pre-amplified return, these devices provide sweepable electronic control over relative phase. Phase ‘alignment’ tools, like the IBP from Little Labs.This can be particularly apparent with signals that have complex midrange harmonic content. For many signals, moving the microphone back and forth along the pick-up axis will reveal a dramatic range of tonal difference. ![]() There are two great options for addressing the relative phase of these two signals (options that put a polarity switch to shame): In applications where the originally recorded signal and the re-amped signal will be used in the mix together, their relative phase is an important tone-shaping factor. If your goal is to use the amps and pedals as signal processors, the adapter ought to facilitate that work, not pile on its own distortion. However, the passive DI fails to simply supply a properly adapted signal. That’s not to say you can’t get the signal flow happening with a passive DI and an adequate amount of attenuation. These are important characteristics of inductive systems. The same cannot be said of a typical passive direct box. The purpose-built re-amping devices (most of which are derivative of John Cuniberti’s early 1990’s design) have the distinct advantage of being designed to operate in the amplitude and impedance ranges typically found in +4dBu pro audio and the instrument amplifier world.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |